HJC ChatterBox iJet 2 Way LCD Remote
|
|
Sizing Information:
- Compatible with all bottom docking iPods (4th GEN and up) including the new Nano and 5th GEN video iPod
FAQ’s:
Q. I have no audio, or I can’t control my audio?
Answer: The iJet Two-Way LCD Remote has a 3.5mm audio output at the Bottom of the 30-Pin receiver. YOU MUST connect the audio line through this port in order to control audio.
Q. I have installed the battery, but my iJet Two-Way LCD Remote is not powering up?
Answer: Please insure that the battery is installed correctly. When holding the remote upright the male (positive +) end of the battery should be facing down. * If installed correctly the male end will rest against the small spring in the plastic battery cap.
NOTE: As an additional trouble shooting step, please check to insure that the battery is not bad.
Q. I can’t seem to get my iJet Two-Way LCD Remote to load list correctly.
Answer: Every so often we hear of a unit not responding, not loading correctly, or displaying Out of Range. If you experience this please follow these simple steps to clear the remotes microprocessor.
1. Turn your iPod on 2. Attach the 30-pin receiver to the bottom of your iPod 3. Take your remote and press the center button on the front pad (Play/Pause) and the “Artist button (middle button on the side) at the same time. Press buttons at the same time and release; do not press and hold. Timing is crucial, so you will know you have correctly initiated the ‘re-load” command when you see Loading………. 4. Step 3 may take up to five minutes to complete, depending on number of artists & playlists. Do not disturb process! 5. After process is finished press Artist button to verify that your artists have loaded correctly.
NOTE: The download process can be affected by outside RF interference. You may need to attempt this process two or three times to insure entire list download.
Q. Do I need to download both lists?
Answer: No. Once you download Artists or Playlists both lists will load.